Residential · Mesa, AZ
Apex Asphalt Mesa has served Mesa since 2017, installing and repairing asphalt walkway surfaces that stay smooth, safe, and low-maintenance. We build new paths and fix cracked, settled, or raveled walkways with proper base work, clean edges, and tight compaction.
Prep and base determine how long an asphalt walkway lasts, so we start with excavation and layout for correct slope and drainage. We remove unstable material, proof-roll the subgrade, and install a compacted aggregate base (typically 4-6 inches of ABC or decomposed granite, adjusted for soil and loads). Base is placed in lifts and compacted with a plate compactor or small roller, then we set edge restraint as needed (concrete mow strip, steel edging, or tight sawcut tie-in to existing pavement) to prevent spreading and edge breakup.
Mesa heat and sudden monsoon runoff are hard on thin pavement, so we design the mix thickness and finish for the site, not a one-size-fits-all patch. Most asphalt walkway installs run 2-3 inches compacted over a properly graded base, with transitions feathered to concrete, pavers, or driveway aprons to avoid trip points. We use a clean hot-mix asphalt mat, consistent rolling patterns, and hand work at curves, gates, and tight corners, then check cross-slope for positive drainage so water does not pond and soften the base.
Mesa property owners choose us because we do walkway work like a contractor, not a handyman patch. Licensed and insured, we provide a free written estimate with line-item scope, thickness targets, and repair options such as infrared heat repair, sawcut removal and replacement, skin patching, and crack filling (hot rubberized crack sealant where appropriate). You get clear scheduling, protection for landscaping and irrigation heads, and a crew equipped with the right tools, including a skid steer for base work, asphalt lute rakes, plate compactors, and rollers.
At closeout we do a final walkthrough to confirm edges, transitions, and drainage, then review curing and use guidelines. You receive a clean jobsite, defined walkway width, smooth tie-ins, and repaired trip hazards, plus recommendations for sealcoating timing (typically after the asphalt has cured) and ongoing crack maintenance. For repairs, we explain what was done, what was not needed, and what to watch for so you can plan proactively instead of reacting to bigger failures.
Yes. We provide a free written estimate after a site visit so we can verify square footage, access, and what prep is required.
Light foot traffic is often possible the same day, but vehicles should typically stay off for at least 24-48 hours depending on temperature, mix, and thickness. We’ll give you a specific reopen time at the jobsite.
Yes. We correct grades with milling, regrading, and asphalt leveling where appropriate, then pave to establish consistent slope and proper tie-ins at concrete, gutters, and entries.
Yes. We handle parking lot paving, overlays, patching, crack sealing, and sealcoating, and we can phase work to keep access open.
Crack sealing typically includes cleaning and sealing cracks with rubberized crack filler to reduce water intrusion. Sealcoating applies a protective coat over the surface after prep work, but it does not correct failed base or deep structural cracks.
An asphalt walkway is a practical way to connect entries, side yards, pool areas, parking lots, and outbuildings with a smooth, slip-resistant surface that is easy to maintain. Apex Asphalt Mesa installs new asphalt paths and completes targeted repairs for cracks, settlement, and edge failure, using proper excavation, base compaction, and hot-mix asphalt placement so the walkway stays even and drains correctly.
For new construction, the most important factor is the foundation under the mat. We grade the subgrade, remove soft areas, and install aggregate base in compacted lifts. Then we place hot-mix asphalt at the right compacted thickness for foot traffic and light service loads, roll it for density, and hand-finish edges and curves so the walkway looks clean and stays supported. If your project ties into existing pavement, we can sawcut a straight joint, apply tack coat at the interface, and blend the new surface so it does not create a lip.
For repairs, we match the method to the failure. Cracking from movement often benefits from routing and crack sealing, while alligator cracking, pumping, or widespread raveling usually indicates base issues and calls for sawcut removal and replacement. Where conditions allow, infrared heat repair can rework the existing asphalt and correct minor defects without a full tear-out. We also correct drainage problems by adjusting grade or adding surface transitions so water is not forced into joints.
If you need an asphalt walkway installed or repaired, we will measure the area, review drainage and access, and provide a written plan with options based on budget and longevity. The goal is simple, a path that looks neat, feels stable underfoot, and holds up through heat, rain, and daily use.
Call now or send a request and we will reach out within one business day to schedule your free, no-obligation estimate in Mesa. We assess the project, review the details, and give you a written quote before any work starts, so you know exactly what to expect.
Prefer to write? Contact us or head back to the home page.
